#Throttle III# Throttle III/Pad VII tablet log collection

 Steps

>Setting>System>About Device>Click 5 times "Build number"

>Setting>System>Developer Options>Turn on "USB debugging"

>Open Calculator> input "!^!^3646633^!^!"


>Slide left 4 times


>Select MTKLogger



>Click the bottom red triangle button to start log collection



> Start repeating the bug and then switch back to log collection software, click the bottom square to stop log collection.


>Home page>ES File Explorer

>Find "mtklog" folder and then copy this folder to a flash drive and send it to the engineer.



Comments

Post a Comment

Popular posts from this blog

#Smartlink J2534# Launch J2534 Driver can’t work normally with GM Techline Connect Debugging

Image
 Error Info Figure-1 Solution 1. Connect Smartlink C to the internet, and upgrade its system and firmware to the latest version. Figure-2 Figure-3 Figure-4 you may need to enter WLAN connect to Wifi 1stly or connect with the ethernet cable. 2. Check already installed the latest version driver,  Currently, by 2023/10/23, the latest version is V2.1. You can download from https://www.launchtechusa.com/downloads Or refer to this video: https://www.youtube.com/watch?v=hcb9S6L0XDc Figure-5 3. Connect the vehicle to Smartlink C with a USB cable, and it show Connected on the Smartlink C PC driver page(Figure-5), and on Smartlink C, it will show Figure-6. Figure-6 USB mode, The vehicle is communicating. If not, please check the connection, change another USB cable, turn on the ignition, or do other operations to make it work. 4. Make sure you already select Launch Smartlink as the GDS2 tech driver. >Launch Techline program> Standalone mode > Connect to vehicle > Select a device type
Read more

#Tech2Tech# Device side control Device side Guide

Image
 Steps Assistant Side( Jake) Homepage> Tech2Tech> Contacts> type in the sn to be assisanted> Search > Click Remote Diagnose> Request Control Remote Device  > Wait Tom accept the request Device to be assistant Side( Tom) Homepage> Log in App > Accept the request sent by Jake, and then tech2tech starts. Jake's tool screenshot Jake-1 Jake-2 Jake-3 Jake-4 Tom's tool screenshot Tom-1 Tom-2 Tom-3
Read more